Behavior and process of background signal formation of hydrogen,carbon, nitrogen,and oxygen in silicon wafers during depth profiling using dual-beam TOF-SIMS

The behavior and mechanism of background signals during depth profiling of atmospheric elements using dual-beam time-of-flight secondary ion mass spectrometry (TOF-SIMS) have been experimentally investigated for silicon wafers. The background signals of atmospheric elements were found to be inversely proportional to the sputtering rate. Most of the background signals are largely attributable to the accumulation of components through adsorption and ion bombardment in the pre-equilibrium state. On the other hand, the contribution of real-time adsorption during the instant after the last sputtering in the equilibrium state is negligible under the present experimental conditions. H₂O is dominant in the background formation process of hydrogen and oxygen, which is supported by the higher adsorption coefficients. The background levels of carbon and nitrogen are lower than those of hydrogen and oxygen. Furthermore, the background signal of carbon with respect to the sputtering rate shows a different trend than the other elements. This could be attributed to accumulation in the pre-equilibrium state. These results indicate that the background levels can be lowered close to those of dynamic-SIMS by using an extremely high sputtering rate in dual-beam TOF-SIMS.     

皮肤组织容积脉搏波400~1000 nm光谱特性仿真研究

根据皮肤组织解剖结构特性建立了六层层状模型,并给出了皮肤组织各层的特性参数;考虑了氧合血红蛋白和还原血红蛋白的吸收特性,依据皮肤组织各层的水、血、脂肪、血氧饱和度含量以及血管大小给出了皮肤组织各层的光谱吸收系数;对不同波长散射系数做了适当简化,给出了皮肤组织各层的光谱散射系数。利用蒙特卡罗方法仿真血管组织在收缩与舒张两种状态下, 400~1 000 nm波长光在皮肤组织多层模型中的传输过程,并通过统计大量光子的分布特性,获得了皮肤组织光谱反射系数,并利用模拟所得的两种状态下的反射系数计算得到了光谱容积脉搏波幅度。仿真结果表明,当入射光强一定时,绿光的容积脉搏波幅度优于红光和蓝光。通过计算不同波长光沿皮肤组织深度方向光能流率衰减为1/e时对应的皮肤组织深度,获得了皮肤组织光谱穿透深度。结果显示,血管舒张状态下蓝光和绿光的穿透深度较小,蓝光大部分只能达到表皮层,绿光能到达微循环层,红光可直达真皮层。考虑到光在皮肤组织中传播包含了一个从收缩到舒张的动态过程,基于此,根据穿透深度定义了脉搏波信号产生深度,利用血管舒张与收缩两种不同状态下的穿透深度计算得到了光谱产生深度。结果表明,不同波长光产生深度大于其穿透深度,蓝光产生深度较浅,且其受到的血液吸收调制较小,因而其获得的脉搏信号易受噪声干扰;红光的容积脉搏波产生深度较大,但是相比于绿光其受血液吸收调制较小,且绿光产生深度足够达到真皮血管层,因而红光容积脉搏波的幅度小于绿光。上述仿真结果明确了皮肤组织部分光谱特性,为皮肤组织多光谱容积脉搏波的精确获取及其他相关研究提供了一定的理论基础。     

Study of water uptake in poly(ether ether ketone) irradiated by MeV O+ and Au+ ions

Poly(ether ether ketone) (PEEK) was irradiated with 4?MeV O⁺ and 5 and 10?MeV Au⁺ ions to the fluences from 10¹² to 10^14?cm^?2 and then treated in 5 M/l water solution of LiCl for one month at room temperature. After drying and removal of LiCl surface contamination, the depth distribution of LiCl embeded in PEEK was measured by the neutron depth profilig method (NDP) sensitive to ⁶Li isotope. Embeded LiCl is believed to map distribution of water diffusing into PEEK interior. The results show that the PEEK irradiated to the fluences above 1.10¹³cm^?2 is prone to water penetration to the depths of few microns. On the pristine PEEK and that irradiated to lower ion fluences only a surface Li contamination is observed.     

FT-IR surface analysis of poly [(4-hydroxybenzoic)-ran-(2-hydroxy-6-naphthoic acid)] fiber – A short review

Instrumental techniques such as Fourier Transform Infrared Spectroscopy (FT-IR) constitute well-studied methodologies for polymer characterization, including polymeric fibers. However, a relatively short number of scientific publications involve the characterization of commercial Poly [(4-hydroxybenzoic)-ran-(2-hydroxy-6-naphthoic acid)] (Vectran™) fiber and its surface species. The majority of the published infrared studies uses the medium infrared region (MIR) associated to the Attenuated total reflection (ATR) method. In this scenario, this short review addresses the characteristics of Vectran™ fiber, sample depth data of each FT-IR spectrum mode, reflection and photo-acoustic spectroscopy (PAS), including near infrared (NIR) analysis. This paper addresses also researches on the characterization of Vectran™ by several FT-IR analysis conditions aiming to contribute to future studies. This brief review deals with methodologies developed in the last decade and published by several scientific research groups, emphasizing studies conducted in the last five years. A critical assessment and trends are also included.     

非正态变异下的非线性轮廓异常点识别方法研究

在质量控制领域,非线性轮廓异常点识别问题是重点研究问题之一。本文综合运用了小波分析、数据深度、聚类分析等数据分析处理技术,提出了一种新的非正态变异的异常点识别方法。文章通过仿真分析技术,将新方法χ²与控制图方法进行性能对比,结果证实新方法能够以更高的准确率和稳定性识别异常点,表现出更好的异常点识别性能。最后将新方法应用于木板垂直密度轮廓实例对新方法进行验证,分析结果表明本方法能够有效识别出异常轮廓数据。     

Rapid synthesis of bovine serum albumin-conjugated gold nanoparticles using pulsed laser ablation and their anticancer activity on hela cells

Nanoscience research aims to produce nanoparticles without adverse effects for medical applications. The pulsed laser ablation (PLA) technique was utilized in this study to synthesize gold nanoparticles (AuNPs) using bovine serum albumin (BSA) in simulated body fluid (SBF) at the fundamental wavelength of the Nd: YAG laser (1064 nm). BSA acted as a stabilizer, reducing and capping agent to produce spherically shaped AuNPs (diameter 3–10 nm). The successful synthesis of AuNPs was confirmed through color changes and UV–vis spectroscopy. The agglomeration and precipitation of AuNPs are attributed to the presence of BSA in the solution, and electrostatic repulsion interactions between BSA and Au nanoclusters. The effect of salt concentration of SBF on BSA stability as well as the interaction of BSA conjugated AuNPs to form complexes was studied using molecular dynamic simulations. Our results show that the stability of AuNPs-BSA conjugates increase with the salt concentration of BSA. Moreover, the synthesized AuNPs exhibit low toxicity and high biocompatibility, supporting their application in drug delivery. Investigation of the cytotoxic effect of the synthesized AuNPs show that normal fibroblast cells (L929) remain intact after treatment whereas a dose-dependent inhibition effect on the growth of cervix cancer cells (HeLa) is observed. In general, this study presents an effective, environmentally-friendly, and facile approach to the synthesis of multifunctional AuNPs using the PLA technique, as a promising efficacious therapeutic treatment of cervical cancer.     

Activation-induced layered structure in NiCoAl by atomic modulation for energy storage application

The surface activation of alloys favors their electrochemical interactions, ion diffusivity, and the rapid kinetics of ions and electrons, leading to the formation of self-supported layered double hydroxides (LDHs) in them. However, the formation of LDHs at different depths in the alloy upon activation, their electronic/atomic structures, and their electrochemical charge storage mechanism, have not been thoroughly explored. Herein, Ni ion-substituted CoAl alloys are prepared by arc melting and activated by KOH electrolyte, which is responsible for the modulation of the atomic configuration as confirmed by XRD. Raman depth mapping demonstrates how the LDHs vary with depth upon activation and that the octahedral and tetrahedral symmetry sites of CoO and Co₃O₄ are responsible for the formation of the layered structures of CoOOH and Co(OH)₂, respectively. The activated Ni₁₀Co₈₅Al₅ has a superior volumetric capacitance of 4.15 F/cm³ at 0.5 mA/g, which is 38.6 times that of an unactivated one, and excellent cyclic stability up to 5000 cycles, and a voltage of 0.54 V generated from a fabricated supercapacitor cell. X-ray Absorption Spectroscopy (XAS) analysis indicates greater charge transfer by Co than by Ni and the modulation of the local atomic structures facilitates electrochemical charge storage in Ni₁₀Co₈₅Al₅. This work presents an easy route for the development of advanced LDHs, and the mechanism of electrochemical charge storage in them.     

Fabrication and characteristics of self‐aggregation nanoparticles used for conformance control treatment

In order to alleviate the contradiction between injectability of the profile control agent and its profile control performance, a novel core‐shell heterogeneous structure colloidal particles (CSA) were synthesized, and the mechanism of self‐aggregation plugging was proposed. Cross‐linking inside the nanoparticles and chain‐growth polymerization via capturing acrylamide in the aqueous phase result in the formation of core‐shell heterogeneous structures as proved by TEM observation and XPS analysis. Moreover, CSA nanoparticles exhibit good hydrophilic properties, outstanding thermal stability and limited expansion capacity. Effects of different metal cations and surface group on the self‐aggregation time of CSA nanoparticles were systematically studied. Results showed that divalent cations contributed to more significant aggregation of CSA nanoparticles in comparison to monovalent cations. The increasing cations concentration and valency decreased the thickness of electric double layer, which lead to a decrease in the zeta potential. Core flooding test shows that the injection of nanoparticles which diameter is much smaller that of pore‐throats into the target reservoir can not only successfully enter the depth of porous media, but also effectively block the high permeability areas by the formation of self‐aggregation particle clusters. This study provides a new method for the equilibrium between nanoparticles injectivity and in‐depth profile control of nanoparticles.     

梁板结构埋入压电片的深度和厚度优化研究

根据梁的弯曲变形理论，以及压电材料的压电效应，对压电复合材料梁结构的应变和应力状态进行了分析。推导了压电材料埋入梁结构时其埋入深度和压电材料本身厚度的优化目标函数。根据优化目标函数，绘制出了在给定的基体材料和压电材料弹性模量比之下，压电材料的驱动力矩随埋入深度和压电材料厚度变化的三维曲面和等高线图，直观地表示出了埋入型压电材料智能结构获得最佳驱动力矩的配置方案。同时也分析了结构和压电材料两者的弹性模量之比对其结果的影响。结果表明，压电材料对于结构的作动力矩与其埋入基体材料的深度、本身厚度以及基体材料和压电材料的弹性模量之比都有着密切的联系。同时将结果也推广到了压电板结构，此时压电材料和基体材料的泊松比时其结果也有一定的影响。